Page 1 of 1

Joined the ranks

Posted: Mon Mar 20, 2017 11:22 am
by martink
Well, I've now joined the ranks of the 3d printers with the acquisition of a Flashforge Creator Pro on Friday. After the usual batch of (scaled down!!) trial prints, it was time for some more serious experimentation.

The first objective: 4-wheel wagons, starting with the chassis. My first half-way reasonable attempt...
DSCI0027.JPG
DSCI0027.JPG (113.09 KiB) Viewed 959 times
DSCI0028.JPG
DSCI0028.JPG (212.29 KiB) Viewed 959 times

Re: Joined the ranks

Posted: Mon Mar 20, 2017 12:17 pm
by dkightley
Hi Martin

Looking good.......

Watch out for an email!!!!


Doug

Re: Joined the ranks

Posted: Sat Mar 25, 2017 11:02 am
by martink
Found a little bit of time to continue experimenting, this one a CAD script to generate footbridges with arbitrarily complex geometries. Still playing with the settings and supports, so this example is in raw form just as it came off the printer...
footbridge1.JPG
footbridge1.JPG (53.67 KiB) Viewed 4501 times
DSCI0029.JPG
DSCI0029.JPG (158.42 KiB) Viewed 959 times

Re: Joined the ranks

Posted: Sat Mar 25, 2017 10:25 pm
by dkightley
That's seriously impressive, Martin!

Here's my first and only attempt at a printed footbridge from back in 2013:
P1010039_red.jpg
P1010039_red.jpg (24.92 KiB) Viewed 5662 times

Re: Joined the ranks

Posted: Mon Mar 27, 2017 3:05 pm
by vinceherman
Awesome Martin!
I also have a FF Creator Pro. I havenot tried to print anything for the TGauge set yet.