Page 1 of 1

Layout size

Posted: Sun Nov 29, 2020 10:29 pm
by barneyadi
Hi

Returning to T gauge but wanted to check if a layout size of 120 cm by 45 cm would work. Looked at anyrail and the curves seem to work, but just wanted to double check.

Thanks,

Re: Layout size

Posted: Wed Dec 02, 2020 2:18 am
by dkightley
You'll have to be careful over choice of rolling stock. Nothing too long....I think only the 16mm power chassis will negotiate the 45cm diameter curves.

And the new shunter. Almost forgot about that!

Re: Layout size

Posted: Wed Dec 02, 2020 6:34 am
by martink
There might be a mis-interpretation there. 45cm is 18 inches, which is quite wide for a T Gauge layout, and allows plenty of room for the widest of the standard curves. My old Sarum Bridge was 150 x 45cm, just a little bit longer than that.

Re: Layout size

Posted: Wed Dec 02, 2020 10:11 am
by dkightley
Whoops. Egg on face! I should have gone to bed rather than answering the post!

Martin's quite right in what he says......

Re: Layout size

Posted: Wed Dec 02, 2020 3:34 pm
by barneyadi
Thanks guys

Have actually found a piece of 4ft by 2ft wide which i think will be perfect, so a little wider which will help. Looked at the Beachcomber trackplan on Tgauge.com as a starting point at least. Got both types of track, normal and flexi and not planning on points at the moment. Got the 4 car 125 set (also something else i cant remember what). The embossed plastikard is exciting for builds. Has anyone used it yet?