Board index ‹ Talking T Gauge Forum ‹ 3D Printing for T Gauge

[dkightley]

Some time ago, I was asked if I could produce some standard viaduct sections that could be used with the basic track sections. I did so....and I believe a couple of shots of samples appeared on the forum...posted by Jim Rusk.

I've recently actually got a bit further with the set following Jim asking me to supply him with some for his small ready-built layouts. So far, I have finalised single trach versions that will fit underneath each of the four 30 degree curved tracks and the 30mm long and 60mm long straights. Here's a couple of shots of a 120mm rad ius curved section and a 30mm long straight section......with and without inserts fitted that hold flexible track.

IMG_3561_red.JPG (55.69 KiB) Viewed 2281 times

IMG_3558_red.JPG (49.41 KiB) Viewed 2281 times

I can't show track sections in these viaduct sections....as I don't have any spare track sections laying about!! But take my word that the viaduct will take them!

I hope to have them added to the shop in the next week ……….followed by twin track versions.

[gbtrains]

Hi Dough
You have done well on these viaduct sections.

It took me quite a while to print off my viaduct sections for the Ribblehead in double track mode without track channels so that you can have it either single or double track laying.

hop eto see some soon then.

Regards
Graham

[jesse6669]

Good looking modular viaduct, could pass for brick, stone or poured concrete when painted!

[Nutter]

one month later still waiting to see them in the shop with prices

[dkightley]

And to re-quote the title...….better late than never, I have finally got round to adding a range of single trach viaducts to the Talking T Gauge shop.