Board index Talking T Gauge Forum T Gauge Custom Rolling Stock

Post details of your rolling stock developments - locomotive, carriages, DMUs, etc.

Re: Pennsylvania 4-6-2 Steam Locomotive.

Postby ivanf » Fri Mar 03, 2017 2:08 pm

PetrOs wrote:Hi,

Slightly smaller worm gears available here ... ecken.html


Thanks PetrOs, I was thrown by there being no picture on that page but I've got it now.

JoeMalinchak wrote:Did you purchase your 2.85mm gears with a 1mm hole or a 1.5mm hole?

I got the 1mm hole ones but I did get a set of axels without the gears so hopefully I'll just need to make the holes bigger.

I'll now get on with ordering the wrong worm. :)

Email sent.

Good luck with the check ride.

Posts: 105
Joined: Wed Nov 20, 2013 7:35 pm

Re: Pennsylvania 4-6-2 Steam Locomotive.

Postby JoeMalinchak » Sun Mar 05, 2017 8:44 pm

I had a little time, so I added some more detail to my locomotive. I added a ladder from the valve gear sheet, and some coal to the tender. I used Woodland scenics fine cinders. They seem like the perfect size for coal in this scale!
IMG_7962.JPG (174.44 KiB) Viewed 1402 times
IMG_8017.JPG (129.97 KiB) Viewed 1403 times
IMG_8009.JPG (144.74 KiB) Viewed 1403 times
Posts: 94
Joined: Thu Jun 04, 2015 8:35 am
Location: Greenfield TWP, Pennsylvania (Near Scranton)


Return to T Gauge Custom Rolling Stock

Who is online

Users browsing this forum: No registered users and 8 guests