Board index

by **Nutter** » Thu Dec 07, 2017 4:39 pm

I have ordered one of his Loco/Tender sets from shapeways and was wondering if anyone has any tips for assembling the bogies etc.
Wanted to be different and am getting the Ivatt.
Have ordered some spare plain axles from Alan because the wheel sets I cannabalised from some old 103's have the drive gear on.

by **Nutter** » Thu Dec 14, 2017 10:16 am

Bump.
Loco arrived 10 mins ago, those printed bogies look very fragile - tips please

by **Nutter** » Thu Dec 14, 2017 5:02 pm

: DSCN0180.JPG (209.78 KiB) Viewed 1826 times

This is what I'm worried about.

Straight out of the bag from Shapeways

by **DavidTheMad** » Thu Mar 22, 2018 9:38 pm

Nutter wrote:
DSCN0180.JPG

This is what I'm worried about.
Straight out of the bag from Shapeways

Hi Nutter,
I don't use them, I have had a good few break on me. It is easier to take a bogie from to adjustable chassis and cut in to singles, if needed, or use as a double. All I use is a 1mm drill bit in a pin drill to act as a guide for the screw.

David the Mad

Board index ‹ Talking T Gauge Forum ‹ T Gauge Custom Rolling Stock

OzRail's steam locomotives. Help Please!!!!

Re: OzRail's steam locomotives. Help Please!!!!

Re: OzRail's steam locomotives. Help Please!!!!

Re: OzRail's steam locomotives. Help Please!!!!

Who is online