Board index Talking T Gauge Forum T Gauge General Discussions

The place for general discussions and requests for help on all matters relating to T gauge.

Another switch / point question

Postby cellocgw » Fri Aug 30, 2019 2:19 pm

Hi,
Very new to this gauge.
I've seen all the discussions about the problem with a dead spot in the existing switch points/turnouts. What I was wondering is: couldn't we just solder a jumper wire from the live rails to the diverter rails to ensure continuous power? These wires could go under the railbed, e.g. . Is there some fundamental construction problem that requires the diverters to be isolated?
cellocgw
 
Posts: 1
Joined: Thu Aug 15, 2019 12:05 pm

Re: Another switch / point question

Postby dkightley » Fri Aug 30, 2019 4:23 pm

It would so nice if that was the problem.....but its not. The problem is that there is a large and long (In T scale terms) piece of plastic that creates a 3/4 inch long dead spot in the middle of the point.

See this thread for a more detailed look at the problem: viewtopic.php?f=12&t=148&hilit=achilles
Doug Kightley
Webmaster here and volunteer at the National Tramway Museum http://www.tramway.co.uk
User avatar
dkightley
 
Posts: 1159
Joined: Wed Nov 13, 2013 9:43 pm
Location: Nottingham, UK


Return to T Gauge General Discussions

Who is online

Users browsing this forum: No registered users and 2 guests


cron